Your Best Source for Sliding Door Repairs!

Patdorroll1

Complete Service, Fast & Affordable!

We have over 40 years of experience in repairing sliding doors. We assure our customers that their expectations will be exceeded by our trained and speedy technicians. Our entire list of services can be found below:

  • Sliding Door Repair
  • Complete Mobile Service
  • Rollers, Locks, Handles and Tracks
  • Glass Patio Doors
  • Vinyl Door Track Repairs
  • Roller Repair
Contact us

Sliding Door Repair

No matter what kind of sliding door you have, we’ll be able to fix it.

Complete Mobile Service

We have the capacity to complete work without the need to leave your location.

Straight Forward Consultation

Our prompt, thorough evaluation of door problems helps you understand our process.

Full Service

We offer complete repair service, so we can tackle whatever problems arise.

Fully Stocked Trucks

Most types of hardware is stocked on our trucks, so we are always prepared.

Top Notch Service

We provide fast, affordable repairs, typically done the same day.

Our technicians are the best in the business

When it comes to repairing sliding doors, we can confidently say, “we’re the best”. We have a large selection of rollers and parts on hand to fit almost any door. We carry parts for many types and brands of doors so we can make repairs in one visit.

Our service package includes replacement of rollers, properly aligning panels and locks, and cleaning tracks. In cases where there is bottom track damage, there are a couple of options available.

 

Track Saver
If a track bead has waives, divots, or dents because of worn out rollers. We install a stainless steel C cap over top of the damaged bead, filing in the divots with silicon and proving a smooth dent resistant surface for the door to roll on.

 

Track Replacement
If the track bead is damaged too severely for a track saver, track replacement is the only solution, besides a new door. We remove the panels from the opening, pull up the old track, loosen and pull the side jambs from the wall. We then apply a waterproofing adhesive in the corners and under the new track, fasten down new track with galvanized Tapcon screws into the concrete slab. Reattach side jambs, caulk inside and out and replace rollers at a discounted price from our normal repair cost.

 

Sliding Glass Door Cut-Down
If the header (the supporting wood beam over the door) has dropped in the middle (header sag) and the doors are binding and not opening, there are two options. 1) A new door or 2) we would have to order new glass (1/8” to ½” shorter) and disassemble the frame, cut the sides down, and rebuild panels with new glass. Because of the extended amount of time it takes the header sag to occur, rollers in the door will most likely need to be replaced.